SpacePC Airstation
The SpacePC Airstation continuously monitors indoor air quality with a Sensirion SEN66 and presents the most important readings, a 60-minute CO₂ trend and an easy-to-understand ventilation recommendation directly on its colour touch display.
- Build time
- 15 min
- Cost
- from €169.00
- Firmware
- 0.1.0 stable
Matching hardware
SpacePC Airstation Kit
from €169.00
Package contents and variants
SpacePC Airstation Kit
- Kit without enclosure — Waveshare ESP32-P4 touch-display board, Sensirion SEN66, matching cable and mounting screws. A printed enclosure is not included.
- Kit with 3D-printed enclosure — Complete kit including the matching 3D-printed enclosure.
Features
Air quality at a glance
The 4.3-inch colour display presents CO₂, PM2.5, PM10, VOC Index, NOx Index, temperature and relative humidity in a clear dashboard.
Sensirion SEN66
A single Sensirion SEN66 sensing module captures the relevant particulate, gas and indoor-climate measurements.
CO₂ monitoring
Assembly and wiring
Assembly and wiring are described in the linked project documentation.
Open documentationFirmware installation
Checking browser firmware installation support...
Home Assistant setup
Install the SpacePC integration in Home Assistant and make sure Home Assistant and the Airstation are on the same local network. The integration discovers the device locally and adds CO₂, particulate matter, VOC, NOx, temperature and humidity as entities. MQTT and cloud access are not required for this integration path.
Install the SpacePC integrationComments (0)
Questions, experiences or notes about this project. New contributions are reviewed before publication.
No comments yet. Start the discussion.